Table of Contents
Advertisement
Features Available
via Pod
Commands
Note
5-2 Using the Emulator
Several emulation features available in the Terminal Interface but not
in the Softkey Interface may be accessed via the following emulation
commands.
display pod_command <RETURN>
pod_command '<Terminal Interface
command>' <RETURN>
Some of the most notable Terminal Interface features not available in
the softkey Interface are:
Copying memory.
Searching memory for strings or numeric expressions.
Performing coverage analysis.
Refer to your Terminal Interface documentation for information on
how to perform these tasks.
Be careful when using the "pod_command". The Softkey Interface,
and the configuration files in particular, assume that the configuration
of the HP 64700 pod is NOT changed except by the Softkey Interface.
Be aware that what you see in
"modify configuration" will NOT reflect the HP 64700 pod's
configuration if you change the pod's configuration with this
command. Also, commands which affect the communications channel
should NOT be used at all. Other commands may confuse the protocol
depending upon how they are used. The following commands are not
recommended for use with "pod_command":
stty, po, xp - Do not use, will change channel operation and hang.
echo, mac -Usage may confuse the protocol in use on the channel.
wait -Do not use, will tie up the pod, blocking access.
init, pv -Will reset pod and force end release_system.
t - Do not use, will confuse trace status polling and unload.
Advertisement
Table of Contents
