Table of Contents
Advertisement
Pin Protector
(H8/329 Only)
Installing the Target
System Probe
H8/338 Emulator
HP 64793A H8/338 emulator is shipped with a non-conductive pin
guard over the target system probe.
H8/329 Emulator
HP 64793B H8/329 emulator is shipped with a conductive plastic pin
guard over the target system probe pins. When you do use the
emulator, either for normal emulation tasks, or to run performance
verification on the emulator, you must remove this conductive pin
guard to avoid intermittent failures due to the target system probe lines
being shorted together.
The target system probe of the H8/329 emulator has a pin protector that
prevents damage to the probe when inserting and removing the probe
from the target system microprocessor socket. Do not use the probe
without a pin protector installed. If the target system probe is installed
on a densely populated circuit board, there may not be enough room for
the plastic shoulders of the probe socket. If this occurs, another pin
protector may be stacked onto the existing pin protector.
1. Remove the H8/338 microprocessor from the target system
socket. Note the location of pin 1 on the processor and on the
target system socket.
2. Store the microprocessor in a protected environment (such as
antistatic foam).
3. Install the target system probe into the target system
microprocessor socket.
4.
3-3 In-Circuit Emulation
Advertisement
Table of Contents
