Selecting An Operating Mode; Setting The Desired Temperature; Swivel Function; Timer - Silvercrest SHLF 2000 D1 Operation And Safety Notes
This product is only suitable for well insulated spaces or occasional use
Hide thumbs
Also See for SHLF 2000 D1:
- Operation and safety notes (90 pages) ,
- Operation and safety notes (103 pages) ,
- Operation and safety notes (75 pages)
Table of Contents
Advertisement
Available languages
Available languages
˜ Selecting an operating mode
Switching the mode: Press
corresponding operating mode indicator 23 is
shown in the display 6 :
Display Operating mode
Fan
In fan mode, no heating level is
activated.
Half heating level
50 % heating power
Full heating level
100 % heating power
Automatic heating level
The product automatically adjusts
the heating level to the ambient
temperature.
Frost protection
At room temperature under +6 °C,
the product turns on automatically.
The product heats the room until the
temperature exceeds +12 °C.
At a temperature of +12 °C, the
product turns off automatically.
NOTE: Whether heating level
appropriate selection, depends on the room size.
We recommend first operating the product on
heating level
.. Switch to heating level
heat output on heating level
˜ Setting the desired temperature
NOTES:
The temperature values are displayed in Celsius
(°C).
The target temperature 26 and the room
temperature 25 are shown in the display 6 .
Select a heating operating mode ( ,
with
5 .
14 GB/CY
5 . The
˜ Swivel function
The built-in swivel function allows the product to
swivel to the left and right. The air flow is thereby
evenly distributed in the room.
˜ Timer
The timer turns off the product automatically after a
preset time elapses.
or
is the
if the
is not sufficient.
or
)
Set the desired temperature 26 with
9 .
As soon as the room temperature 25 reaches the
set target temperature 26, the product switches
off automatically.
The product automatically switches back on
again as soon as the room temperature 25 falls
below the set target temperature 26. In active
heating operation, the control lamp 11 is lit.
Turning the swivel function on/off: Press
When the swivel function is active,
shown in the display 6 .
Setting the timer: During operation, press
The hour display starts flashing.
Set the hours with
Press
3 to confirm.
The minute display starts flashing.
Set the minutes with
Press
3 to confirm or wait for 5 seconds.
When the timer is set,
24 are shown in the display 6 .
After the set time runs down, the product turns off
automatically.
NOTE: When the product has been turned off
by the timer, End is shown in the display 6 .
If no button is pressed within 5 seconds after
3 was pressed, the timer setting will be aborted.
7 and
4 .
22 is
7 and
9 .
7 and
9 .
and the remaining time
3 .
- Quick Links:
- Selecting an Operating Mode
Hide quick links:
Advertisement
Chapters
Table of Contents
