Unplugging Or Plugging In A High-Speed Scanner (Hss) Cable - IBM 3745 Series Connection And Integration Manual
Communication controller/nways multiprotocol controller
Hide thumbs
Also See for 3745 Series:
- Hardware maintenance reference (712 pages) ,
- Maintenance information reference (595 pages) ,
- Problem determination manual (387 pages)
Table of Contents
Advertisement
0
o
o
o
o
Step
5
Step
6
Activating the lines
Ask the host operator to activate any lines that were plugged in.
Note: The line number is the same as the port number.
You have finished this procedure
If you have no other connection procedures to do, close and lock the
door using the special door key.
Unplugging or Plugging In a High-Speed Scanner (HSS) Cable
Step
1
Starting
Step
If you have not done the procedure "Getting Started" on page 1-2, do
so now.
If you are only plugging in HSS cables, go to Step 3 on page 1-14
Otherwise, continue with the next step.
2 Unplugging an HSS cable
Remove the cable by squeezing the levers and pulling out the plug.
)
]
:
;
)
)
Repeat this step for every HSS cable to be unplugged.
If you are not plugging in an HSS cable, go to Step 4 on page 1-14
Otherwise, continue with the next step.
Chapter
1.
3745 Models 210 to 61A: Connecting L1Cs and Cables
1-13
Advertisement
Table of Contents
