Connecting A Vcr And Cable Tv - Sony WEGA KLV 23M1 Operating Instructions Manual
Sony operating instructions lcd color tv klv-23m1
Hide thumbs
Also See for WEGA KLV 23M1:
- Service manual (81 pages) ,
- Specifications (2 pages) ,
- Brochure (2 pages)
Table of Contents
Advertisement
Connecting a VCR and Cable TV
VCR
26
Use this hookup if:
• You subscribe to a cable TV system that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR's IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
3
Using A/V and S VIDEO cables, connect the VCR's AUDIO and S VIDEO
OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO 1 IN or
VIDEO 2 IN).
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
75-ohm
coaxial cable
(supplied)
Cable
S VIDEO cable
(not supplied)
A/V cable (not supplied)
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
"Auto YC" in the
When connecting both VIDEO IN and S VIDEO IN
Using the menu, you can select the jack from which the TV receives the input
signal. You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN)
separately. The TV is factory set to receive S VIDEO input signals.
1
Press VIDEO 1/2 repeatedly until the desired video input appears.
2
Press MENU.
3
Press V/v to select
4
Press V/v to select "Auto YC," then press
5
To watch the pictures input from the S VIDEO input jack:
Press V/v to select "On," then press
To watch the pictures input from the VIDEO input jack:
Press V/v to select "Off," then press
6
Press MENU to exit the menu screen.
75-ohm coaxial
cable (supplied)
S VIDEO
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
(Setup) menu is set to "On" to view the S VIDEO input (see below).
(Setup), then press
Rear of TV
.
.
.
.
Hide quick links:
Advertisement
Table of Contents
