Preface; Audience; Purpose; Conventions - Cisco 3110G Hardware Installation Manual

Catalyst switch module for ibm bladecenter

Hide thumbs Also See for 3110G:

Table of Contents

Preface

This guide is for the networking or computer technician responsible for installing a Cisco Catalyst

switch module. We assume that you are familiar with the concepts and terminology of Ethernet and local

area networking.

This guide documents the hardware features of the Cisco Catalyst Switch Module 3110G, 3110X,

and 3012 for IBM BladeCenter—referred to as the switch module. It describes the physical and

performance characteristics of each switch module, explains how to install a switch module, and

provides troubleshooting information.

This guide does not describe system messages that you might receive or how to configure your switch

module. For more information, see the switch module getting started guide, the software configuration

guide, the command reference, and the system message guide on Cisco.com. For information about the

standard Cisco IOS Release 12.1 or 12.2 commands, see the Cisco IOS documentation set from the

Cisco.com home page at Technical Support and Documentation > Documentation. On the Cisco

Documentation home page, select Release 12.1 or 12.2 from the Cisco IOS Software drop-down list.

This document uses the following conventions and symbols for notes, cautions, and warnings.

Translations of the warning statements in this document appear in the Regulatory Compliance and Safety

Information for the Cisco Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter that

ships with the switch.

Means reader take note. Notes contain helpful suggestions or references to materials not contained in

Note

this manual.

Caution

Means reader be careful. In this situation, you might do something that could result in equipment

damage or loss of data.

OL-12192-01

Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter Hardware Installation Guide

vii

Table of Contents

3012 3110x