Installing Tape Drives; Installing System Printers - HP 3000 Installation Manual
Computer system, series 37xe
Hide thumbs
Also See for 3000:
- Limited warranty (17 pages) ,
- Diagnostic manual (10 pages) ,
- Manual (310 pages)
Table of Contents
Advertisement
System Installation
The general installation procedure for these discs is described in the following paragraphs. Refer to the
appropriate disc service and installation manuals for detailed set-up instructions and parts lists.
1. Ensure that the power cords to the SPU and the I/O Extender are disconnected from the line
power source and that the keyswitch is set to the 0 position.
2. Set the disc drive POWER switch, located at the rear of the drive, to the OFF position.
3. Connect the HP-IB device I/O cable to the connector on the rear of the disc drive.
4. Route the HP-IB device I/O cable to a PIC
peA
connector in the SPU or the I/O Extender.
5. If the disc is not installed in the system cabinet, connect the disc drive AC power cord to a
dedicated AC power source with an isolated ground.
6. Ensure that the HP-IB address is set correctly. Refer to the procedure for setting the HP-IB
address in the manual shipped with the drive.
Installing Tape Drives
General instructions for installing tape drives are provided below. Refer to the specific operating and
installation manuals for more detailed information.
Install the tape drive as follows:
1. Ensure that the power cords to the SPU and the I/O Extender are disconnected from the line
power source and that the keyswitch is set to the 0 position.
2. Set the POWER switch on the tape drive to the OFF position.
3. Ensure that the source voltage matches the requirements of the tape drive.
4. Connect one end of the HP-IB device I/O cable to the tape drive and the other end to a PIC
PCA connector in the SPU or the I/O Extender.
5. Connect the power cord from the tape drive to a dedicated AC power source with an isolated
ground.
6. Ensure that the HP-IB address is set correctly. Refer to the procedure for setting the HP-IB
address in the manual shipped with the drive.
Installing System Printers
General instructions for installing system printers are provided below. Refer to the specific operation and
installation manuals for more detailed information.
0984
3-17
Hide quick links:
Advertisement
Table of Contents
