Commands In The Events Configuration Mode; Smtp-Server - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
7.5.2
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
Privileged EXEC mode.
7.5.2.1
smtp-server
Description
With this command, you configure an entry for an SMTP server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN>} <receiver mail-address>
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
receiver mail-
address
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
events
Description
Keyword for an IPv4 address
IPv4 address of the SMTP server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Name of the recipient
no smtp-server
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
-
Enter a valid IPv4 unicast ad-
dress.
-
Maximum of 100 characters
Maximum of 100 characters
command.
Network protocols
7.5 SMTP client
355
Hide quick links:
Advertisement
Table of Contents
