Spanning-Tree Mst Max-Hops - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Network structures
6.3 Spanning Tree
Syntax
Call up the command with the following parameters:
spanning-tree mst{instance-id<instance-id(1-64)>}root
The parameters have the following meaning:
Parameter
instance-id
instance-id
Result
The "root bridge" function is disabled.
Further notes
You enable the root bridge function with the
You display this setting and other information with the commands that start with
spanning tree ...
6.3.3.12
spanning-tree mst max-hops
Description
With this command, you configure the maximum number of nodes (hops) that a path can run
through in an MST.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst max-hops <value(6-40)>
The parameter has the following meaning:
Parameter
value
258
Description
Keyword for the instance
Number of the instance
.
Description
Maximum number of hops that a path
can run through in an MST
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
-
1 ... 64
spanning-tree mst instance-id root
Range of values / note
6 ... 40
Default: 20
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
show
Hide quick links:
Advertisement
Table of Contents
