Vap Wds Id (Access Point) - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
6.1.6.1
vap wds id (access point)
Description
With this command, you set the WDS ID for the relevant VAP interface. To establish a WDS
connection, enter this WDS ID on the WDS partner.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap wds-id <wds id>
The parameter has the following meaning:
Parameter
wds id
Result
The WDS ID for the VAP interface is set.
Note
WDS IDs longer than 32 characters are truncated at 32 characters.
Further notes
You display the setting with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
WDS ID
The WDS ID can be a maximum of 32 characters long.
show wlan vap <vap X 0/Y>
Network structures
command.
6.1 WLAN
207
Hide quick links:
Advertisement
Table of Contents
