Wlan Data Rate-11N Defaults (Access Point) - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
6.1.5.32
wlan data rate-11n defaults (Access Point)
Description
You can reset the selection to the default setting with this command.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11a/b/g/n is set.
● The "Use selected data rates only" function is enabled.
Syntax
Call the command without parameter assignment:
wlan data rate-11n defaults
Result
The selection is reset to the default setting.
Further notes
You display the setting with the
You disable the function with the
You configure the data transmission speeds with the
You configure the transmission standard with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
show wlan data rates
no wlan data rates-11n selected only
wlan data rate-11n
wlan mode
Network structures
6.1 WLAN
command.
command.
command.
185
Hide quick links:
Advertisement
Table of Contents
