Replacing The Hot-Swap Power Supply And Power Supply Filler; Memory Card And Memory Module (Dimm) - IBM System x3800 Problem Determination And Service Manual
Type 8866
Hide thumbs
Also See for System x3800:
- Manual (196 pages) ,
- User manual (104 pages) ,
- Installation manual (88 pages)
Table of Contents
Advertisement
To remove a power supply filler, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Press the orange release latch on the handle and pull the handle to the open
3. Pull the power supply filler out of the bay.
4. If you are instructed to return the power supply filler, follow all packaging
Replacing the hot-swap power supply and power supply filler
To install the replacement hot-swap power supply, complete the following steps:
1. Press the orange release latch on the handle and pull the handle to the open
2. Place the power supply into the bay and fully close the handle.
3. Connect one end of the power cord for the new power supply into the connector
4. Make sure that both the ac and dc power LEDs on the rear of the power supply
To install the replacement power supply filler, complete the following steps:
1. Press the orange release latch on the handle and pull the handle to the open
2. Place the power supply filler into the bay and fully close the handle.
Memory card and memory module (DIMM)
The server supports 333 MHz, 1.8 V, 240-pin, PC2-3200 single-ranked
double-data-rate (DDR) II, registered synchronous dynamic random-access memory
(SDRAM) with error correcting code (ECC) DIMMs. These DIMMs must be
compatible with the latest PC2-3200 SDRAM Registered DIMM specifications. For a
list of the supported options for the server, see http://www.ibm.com/servers/eserver/
serverproven/compat/us/.
Removing and replacing a memory card
At least one memory card with one pair of DIMMs must be installed for the server
to operate correctly.
To remove a memory card, complete the following steps.
124
IBM System x3800 Type 8866: Problem Determination and Service Guide
on page 113.
position.
instructions, and use any packaging materials for shipping that are supplied to
you.
position.
on the back of the power supply, and connect the other end of the power cord
into a properly grounded electrical outlet.
are lit, indicating that the power supply is operating correctly
position.
- Quick Links:
- Light Path Diagnostics
Hide quick links:
Advertisement
Table of Contents
