Snmp Targetparams - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network protocols
7.4 SNMP
Syntax
Call up the command with the following parameters:
no snmp targetaddr <TargetAddressName>
The parameters have the following meaning:
Parameter
TargetAddressName
Result
The SNMP target address is deleted.
Further notes
You change the SNMP target address with the
You display the SNMP target address with the
7.4.2.16
snmp targetparams
Description
With this command, you configure the SNMP target parameters.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp targetparams <ParamName>
user <UserName>
security-model {v1|v2c|v3{auth|noauth|priv}}
message-processing {v1|v2c|v3}[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
ParamName
user
UserName
322
Description
SNMP target address
show snmp targetaddr
Description
Name of the SNMP parameter
Keyword for the user name
Value for the user name
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
max. 32 characters
command.
snmp targetaddr
command.
Range of values / note
max. 32 characters
-
max. 32 characters
Configuration Manual, 11/2014, C79000-G8976-C351-03
Advertisement
Table of Contents
