Dcp Forwarding - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network protocols
7.1 IPv4 protocol
Result
The DHCP assigns the IP address to the VLAN interface.
Further notes
You delete the settings with the
You display this setting and other information with the
7.1.3.4
dcp forwarding
Description
With this command, you configure the forwarding behavior of the interface for DCP frames.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dcp forwarding {block|forward}
The parameters have the following meaning:
Parameter
block
forward
Result
The forwarding behavior of the interface for DCP frames is configured.
276
no ip address
Description
DCP frames are discarded
DCP frames are forwarded
Default:
forward
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command.
show ip interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
Advertisement
Table of Contents
