Switchport Priority Default - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Syntax
Call the command without parameters:
no switchport ingress-filter
Result
The ingress filter is deactivated.
Further notes
You enable the filter with the
You can display the status of the ingress filter and other settings with the
config
6.2.3.6
switchport priority default
Description
With this command, you configure the priority default for the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport priority default <0-7>
The parameter has the following meaning:
Parameter
-
Result
The setting for the default priority of the interface is configured.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
switchport ingress-filter
command.
Description
Value for the priority default
Network structures
command.
show vlan port
Range of values / note
0 ... 7
Default: 0
6.2 VLAN
211
Advertisement
Table of Contents
