Show Wlan Wds (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.1 WLAN
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan vap <vapX 0/Y>
The parameter has the following meaning:
Parameter
vapX 0/Y
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The following settings of the VAP are displayed:
● Admin status
● SSID
● Broadcast SSID
● WDS only
● WDS ID
6.1.1.18
show wlan wds (access point)
Description
This command shows the configuration of the WDS interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
132
or
cli#
or
cli#
Description
Values or range of values
VAP interface
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Advertisement
Table of Contents
