Show Wlan Client-List (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.1 WLAN
6.1.1.9
show wlan client-list (access point)
Description
This command shows a table with the clients logged on with the access point as well as
additional information, for example status, signal strength, MAC address.
Note
The command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan client-list [wlan 0/X [{mac <macaddr> | sys <sysname> | AID}]]
The parameter has the following meaning:
Parameter
wlan 0/X
mac
macaddr
sys
sysname
AID
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The table with the logged-on clients is displayed.
124
or
cli#
Description
WLAN interface
Keyword for the MAC address of the client
MAC address
Keyword for the system name of the client
System name
Connection ID of the client.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Values or range of val-
ues
Enter a valid interface.
-
aa:bb:cc:dd:ee:ff
-
-
Advertisement
Table of Contents
