Table of Contents
Advertisement
15 Power cord set requirements
The wide-range input feature of the computer permits it to operate from any line voltage from 100 to 120
volts ac, or from 220 to 240 volts ac.
The 3-conductor power cord set included with the computer meets the requirements for use in the country or
region where the equipment is purchased.
Power cord sets for use in other countries and regions must meet the requirements of the country or region
where the computer is used.
Requirements for all countries and regions
The following requirements are applicable to all countries and regions:
●
The length of the power cord set must be at least 1.5 m (5.0 ft) and no more than 2.0 m (6.5 ft).
●
All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in
the country or region where the power cord set will be used.
●
The power cord sets must have a minimum current capacity of 10 A and a nominal voltage rating of 125
or 250 V ac, as required by the power system of each country or region.
●
The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet
C13 connector for mating with the appliance inlet on the back of the computer.
Requirements for specific countries and regions
Country/region
Argentina
Australia
Austria
Belgium
Brazil
Canada
Chile
Denmark
Finland
France
Germany
India
Israel
Italy
Accredited agency
IRAM
SAA
OVE
CEBEC
ABNT
CSA
IMQ
DEMKO
FIMKO
UTE
VDE
ISI
SII
IMQ
Applicable note number
1
1
1
1
1
2
1
1
1
1
1
1
1
1
Requirements for all countries and regions 123
- Quick Links:
- Display Components
- Hard Drive
Hide quick links:
Advertisement
Table of Contents
